See install pictures.

Installation
Use a quality heavy duty clear wall covering adhesive. Do not install wall covering on defective surface. All surfaces should be carefully prepared free from cracks, dirt, dust, grease, irregularities and rough spots. Walls are to be thoroughly dry before application.

Please be advised that we do not accept any returns if material has been hung or cut. Prior to the start of installation, examine pattern, colors and repeat in design. Only skilled paper hangers shall install wall covering. Make sure to press down all corners and edges with a roller. Below are Sincol patterns that need special instructions.

A-300 - A-303
Wallpaper becomes softer, easier to handle after moistening with adhesive. We recommend using a generous amount of heavy duty adhesive. Book these patterns loosely. Do not crease or pile up when booking. Always use a sharp blade. Rapid drying after installation will cause gap between joints.

A-304 - A-318
This wallpaper is made from the Lokta plant. Colors and thickness may vary. This paper may be translucent. Moisten the paper with water using a damp sponge. Apply the adhesive directly onto the back of the wallpaper. Start hanging from the bottom up overlapping each square. Hang from floor to ceiling before starting on the next row. Remove excess adhesive as soon as possible using a damp sponge. The paper is fragile so use caution. The leaves on A-317 and A-318 may come off during installation. If this occurs put a thin joint tape on the paper and apply the leave back on. DO NOT use a spatula or roller. Use a brush to let the air out. Keep the temperature at the job site between 60 and 80 degrees.

A-319 - A-350 / A-376 - A-386
This wallpaper is made with paper twine. Colors may vary because of its characteristics; therefore, a noticeable color difference may occur at the joints. Trimmed width should be within a width of 34.6”. Reverse hang every other strip. This wallpaper has excellent moisture permeability, so use a generous amount of adhesive. Book very loosely. Do not crease when booking. Use a soft brush. Wipe off excess moisture and adhesive immediately from the surface. Rapid drying after installation will cause gap between joints. Please be advised that we do not accept any returns if material has been hung or cut.

A-351 - A-354 / A-387 - A-391
Use a sealer on concrete or plywood base surface to avoid moisture and mold. Use a heavy duty clear adhesive and apply adhesive directly on to the back of the wallpaper. Do not leave a long open time (Max 10 minutes). Use a sharp blade when cutting and cut the wallpaper at a 15 to 20 degree angle. Use a soft roller. Wipe off any excess adhesive with a damp sponge. Rapid drying after installation may cause gap between joints.

A-355 - A-375 / A-404 - A-406
The rice paper used for this wallpaper contains natural straw; therefore, a slight difference may occur depending on the time of harvest. Reverse hang every other strip. Book this pattern very loosely. Do not crease. Do not strain the joints by stretching, instead overlap and double cut. Use a soft brush and wipe off any excess moisture and adhesive from the surface. Rapid drying after installation will cause gap between joints. Please be advised that we do not accept any returns or claims on material that has been hung or cut. Because of the characteristics of natural materials, the joints may not perfectly match.

A-392 - A-403
This wallpaper is made with glitter. Please be advised that a slight amount of glitter may fall off during installation. Colors may vary because of its characteristics; therefore, a noticeable color difference may occur at the joints. Trimmed width should be within a width of 34.6”. Reverse hang every other strip. This wallpaper has excellent moisture permeability, so use a generous amount of adhesive. Book very loosely. Do not crease when booking. Make sure to use a soft brush. Wipe off excess moisture and adhesive immediately from the surface. Rapid drying after installation will cause gap between joints. Please be advised that we do not accept any returns if material has been hung or cut.

Cleaning
Sincol wallpapers can be cleaned by using a damp (not a soaking wet) cloth. Use very little pressure while cleaning; too much pressure may cause damage to wall covering. We highly recommend installing these wallpapers in areas where no or little cleaning will be needed. Stains are hard to remove without damaging the beautiful and different finishes of these wallpapers.